FREE SHIPPING
On Orders Over $99
Sales

Select Your Vehicle

Get the parts you need today. Pay later with . Learn more

Questions?

Our USA based
parts pros can help.

Click Here

Industry Leading Warranty

Click to learn more

Community

Home >   How To >   How to Repair Turbocharger >   What is Turbo Lag?

What is Turbo Lag?



What is Turbo Lag?

 

Turbos rely on the flow of the exhaust gas through the turbine housing. As the engine RPMs increase the turbo spools and begins to build boost. The delay between the opening of the throttle and the turbo spinning and producing boost is known as "turbo lag".

 

Why Does Turbo Lag Happen?

 

On average a small turbo can deliver good power early on but runs out of steam pretty quickly, similar to a supercharger. A larger turbo will give a fair kick when the boost comes on and will hold that through the rest of the rev range. This can be an issue however because it can make a car difficult to drive.

 

How to Reduce Turbo Lag

 

Various methods of minimizing turbo lag have been attempted over the years. To get a combination of boost pressure and hence power along with fast throttle response and drivability.

 

1. Sequential Turbo

 

Mazda used a sequential turbo on the last of the RX-7 models, with a small turbo spinning at low to mid-range engine speeds and then a bigger version taking over at high speeds.

 

2. Anti-Lag System (ALS)

 

The current crop of World Rally cars probably have the most efficient system, known as anti-lag (ALS). Details vary from manufacturer to manufacturer but they all work on the same basic principle. A small amount of compressed charge air can bypass the throttle when it's closed. The ignition spark is suppressed at the same time and un-burnt fuel is dumped directly into the exhaust turbine housing, where it mixes with the air and is spontaneously ignited by the red hot wheel. This keeps it spinning so that as soon as the throttle is opened, the turbo's ready to give full boost. Because the throttle is closed during the above process the inlet tract is filled with compressed clean air, so that when the throttle is opened, the cylinders are immediately filled and when the fuel is injected, response is instant. The downside is the ALS process is the massive thermal loads it puts on the turbo and exhaust system, and the heat generated in the engine.

 

3. Blow Off Valve

 

Another method to reduce lag (partly) when changing gear is a blow off valve. Normally on a gearshift the throttle is closed and the air from the spinning turbo backs up against the closed throttle and stalls it. But a blow off valve vents the pressurized air off instead of recirculating it.

 




"How To" Home  |  BuyAutoParts Home



 

Copyright © 2019 Buy Auto Parts. All rights reserved.

  

Click here for Mobile version